Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Spring Repair for Highlands Homeowners
A broken spring is the reason a garage door suddenly won’t lift, or slams down hard when it does. In Highlands, where detached garages and older carriage-style doors are common, a snapped spring leaves you parked on the street and the house wide open. We handle garage door spring repair as a core service, not something we squeeze in between other trades. Our technicians have up to 9 years of experience, and we work on the major brands you’re likely to have. Same-day service is available, and the estimate is free. Call (877) 492-1832. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Key Takeaways
- Typical spring repair in Highlands runs $180 – $340 for one spring; a matched pair is usually replaced together at about twice that.
- We replace torsion and extension springs, install safety cables, and inspect worn hardware before anything else fails.
- Spring repair is a safety-critical job. A loaded torsion spring is under extreme tension and should only be handled by a trained technician.
- We work on Amarr, Wayne Dalton, Craftsman, Raynor, LiftMaster, Chamberlain, Genie, and Clopay equipment.
- The price is quoted and agreed before any work starts, and the written estimate sets the final price.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
What Our Garage Door Spring Repair Service Includes
Spring work covers more than swapping a coil of steel. Below is what we do on each part of the job, what tells you it’s needed, and how we approach it on a Highlands door.
Torsion Spring Replacement
A torsion spring is the horizontal coil mounted above the door on a steel shaft, and it does the heavy lifting for the whole panel. It’s the spring most modern Highlands garages use, and it’s the one that makes a loud snap when it fails. We replace the spring and check the shaft, bearing plates, and drums at the same time, because a worn bearing will finish off a new spring fast. If you have a pair, we’ll tell you plainly whether both should go together, since matched springs wear at the same rate.
Extension Spring Replacement
Extension springs run along the sides of the door on older garages, stretching as the door closes. They’re more common on the older carriage-house and detached garages you still see around Highlands, and they need a safety cable through the center of each one. We replace extension springs and fit those cables so a broken spring is caught instead of flying loose. If you’re not sure which type you have, we’ll identify it on arrival before quoting.
Broken Spring Repair
A broken spring is the call we get most: the door won’t open, or it opens a few inches and stops. We diagnose which spring failed, confirm the door isn’t binding on a track or roller that caused the break, and replace the failed part. Getting the door level and balanced again afterward matters as much as the spring itself. We don’t recommend operating a door with a broken spring, even by hand, because the remaining spring carries double the load.
Spring Adjustment
Some doors don’t need a new spring, just the right tension set correctly. If your door feels heavy, won’t stay up on its own, or drifts down when you let go, the springs may be wound too loose or too tight. We measure the door’s balance and adjust tension to match the door’s weight. A properly adjusted door should hold position halfway open without help.
Safety Cable Installation
Safety cables are the steel cables that run through extension springs so a break is contained rather than launching hardware across the garage. Many older Highlands garages were built before cables were standard, and that’s a real hazard worth fixing. We install cables on both sides and check the pulleys and brackets while we’re there. It’s a small job that removes a large risk.
Spring Inspection
Not every spring call is an emergency, and an inspection catches wear before it becomes one. We check for gaps in the coil, rust pitting, stretched extension springs, and uneven door travel that points to a tired spring. If everything is sound, we’ll tell you so and leave it alone. If a spring is near the end of its life, you’ll know before it strands you.
Brands We Service for Garage Door Spring Repair
We work on Amarr doors and know how their spring setups are sized and mounted, so a replacement is matched to the door’s actual weight rather than guessed. Wayne Dalton equipment comes through often too, and their older extension-spring models are worth a close look at the brackets and cables before we touch the springs. Craftsman doors and their associated openers are common on Highlands homes, and we’re familiar with how those systems balance.
Raynor is another brand we service regularly, and we know where their springs and hardware tend to wear first. Whether you have one of these makes or any other, we can help, and we also service LiftMaster, Chamberlain, Genie, and Clopay. You won’t hear “we don’t work on that brand” from us. Our focus is entirely on garage doors, which is why we can speak to the specifics of each one rather than treating them all the same.
Signs You Need Garage Door Spring Repair Right Now
Springs rarely fail without warning. Here’s what to watch for, and why each sign matters.
- A loud bang from the garage. A torsion spring snapping sounds like a gunshot and usually happens when the door is at rest. It’s the clearest sign a spring has broken and the door should stay closed until it’s repaired.
- The door won’t lift or feels extremely heavy. If the opener strains or you can barely raise the door by hand, the spring has lost its lift. Forcing it can burn out the opener motor as well.
- A visible gap in the spring coil. A break in the coil means the spring has failed, even if the door still moves a little. A gap of an inch or more is a clear sign it’s time to stop using the door.
- The door slams down or won’t stay open. A door that drops hard or won’t hold halfway up points to a spring that’s lost tension. This is a safety concern if anyone walks under it.
- Uneven travel or a door that looks crooked. One spring working while the other has failed makes the door rise lopsided. That imbalance puts stress on the tracks and rollers and can lead to a bigger repair.
Our Garage Door Spring Repair Process – Step by Step
Spring work is methodical. Here’s how a typical Highlands spring repair goes from the first call to the final balance check.
- 1
Phone diagnosis and scheduling. We ask what the door is doing, so we arrive with the right springs and tools on hand. Parts kept in supply mean fewer return trips and a repair that’s finished the same visit whenever possible.
- 2
On-site inspection. We confirm which spring failed and check the door’s balance, tracks, rollers, and cables. A door that’s binding is often what caused the spring to give out, and we want to fix the cause, not just the symptom.
- 3
Written estimate before any work. You get a clear price, quoted and agreed before we start. Nothing gets added to the invoice later that wasn’t on the estimate.
- 4
Careful spring replacement. We wind and unwind torsion springs with the proper winding bars and hold extension springs safely while fitting new ones with safety cables. A loaded spring stores enormous energy, which is exactly why this step belongs to a trained technician and not a weekend project.
- 5
Balance and safety check. We run the door through a full open and close, set the tension, and confirm it holds position correctly. Then we walk you through what we found and what we replaced.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Spring Repair Cost in Highlands?
A typical spring repair in Highlands runs $180 – $340 for one spring, depending on the door’s size, spring type, and how much related hardware needs attention. If your door uses a matched pair and both are worn, expect roughly twice that range, since a pair is usually replaced together. Here are the common scenarios:
| Service | Typical Estimated Range |
|---|---|
| Torsion spring replacement (one spring) | $180 – $340 |
| Extension spring replacement (one spring) | $180 – $340 |
| Spring repair with safety cable installation | $180 – $340 |
| Spring inspection and adjustment | $180 – $340 |
Several things move the price: the door’s weight and height, whether it’s a torsion or extension system, whether bearing plates or drums need replacing, and whether a second spring is worn. Heavy double doors and custom carriage-style doors cost more than a standard single. To avoid overpaying, ask for the estimate in writing before work starts and confirm whether the price covers one spring or a pair. Our free estimate spells out exactly what’s included, and the written quote sets the final price. If we find something during inspection that changes the job, we tell you before we touch it.
Garage Door Spring Repair Near Highlands – Our Service Area
We serve homeowners throughout Highlands and the surrounding neighborhoods, including Berkeley, Bear Valley, Virginia Village, Sunnyside, Sloan Lake, Central Park, Capitol Hill, Cherry Creek, Baker, and out toward Wheat Ridge. Response times depend on where you are and how busy the day is, but same-day service is often possible. If you’re in Berkeley or nearby, our garage door spring repair page covers that area, and Bear Valley homeowners can find local details on our garage door spring repair page. Wherever you are in the area, we’ll get a technician out and give you a straight answer on what’s needed.
Serving Highlands, CO – Our Local Coverage Area
We serve Highlands and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Spring Repair in Highlands
Garage door spring repair is the replacement or adjustment of the torsion or extension springs that counterbalance your door’s weight. The springs do most of the lifting, so when one fails the door becomes very heavy and unsafe to operate. Repair means fitting a new spring or pair, setting the correct tension, and confirming the door is balanced. We treat it as a core service because it’s one of the most common and most safety-sensitive repairs in the trade.
Most single-spring replacements take about an hour once we’re on site, and a matched pair runs a bit longer. The exact time depends on the door type, whether bearing plates or cables also need work, and how accessible the springs are. We’ll give you a realistic window when you call. Since our technicians have up to 9 years of experience, the work moves efficiently without cutting corners.
A typical spring repair in Highlands runs $180 – $340 for one spring, and a matched pair is usually replaced together at about twice that range. The final figure depends on door size, spring type, and any related hardware. The estimate is free, and the price is quoted and agreed before any work starts. Call (877) 492-1832 for an exact quote; estimates are free.
We service springs on Amarr, Wayne Dalton, Craftsman, Raynor, LiftMaster, Chamberlain, Genie, and Clopay equipment. That covers most of the residential doors in the Highlands area, so you’re unlikely to hear that we can’t work on yours. If you’re unsure of your brand, we’ll identify it on arrival. Our multi-brand knowledge means we match the replacement spring to your door’s actual weight rather than guessing.
Same-day service is often available for spring repairs in Highlands, depending on the day’s schedule. Our crews are dispatched Sunday through Friday, 7am to 7pm, and we’re closed Saturday. We answer 24/7, so if you call outside dispatch hours, we’ll book you into the next opening. Call (877) 492-1832 to check availability and get an exact quote.
Warranty terms depend on the spring and the specific job, so we spell them out on your written estimate before work begins. You’ll know what’s covered on your replacement parts and labor before we start. We don’t make blanket promises that don’t match the actual job. Ask us about coverage for your door when you call, and we’ll be specific.
Clear the area around the garage door and move anything parked directly under it, especially if the door is stuck open. Leave the door alone rather than trying to lift it, since a broken spring makes it dangerously heavy. Make sure we can reach the garage, and let us know if there’s anything unusual about the door’s operation. That’s all we need. Call (877) 492-1832 to set up the visit.
Schedule Your Garage Door Spring Repair Service in Highlands Today
A broken spring doesn’t fix itself, and the door stays unsafe until it’s repaired. Call (877) 492-1832 for a free, no-obligation estimate on spring repair in Highlands. We answer 24/7, dispatch runs 7am to 7pm Sunday through Friday, and same-day service is often available. You’ll get a written price before any work starts, and the estimate sets the final cost. One call gets your door balanced and working again.
Written by the team at Highlands Garage Door Repair Pros.